In this quick Arduino tutorial I will explain how you can control a relay using the Arduino Board, one 1K and one 10K resistors, 1 BC547 transistor, one 6V or 12V relay, one 1N4007 diode and a 12V fan ...

In this Arduino Relay Control Circuit we have used Arduino to control the relay via a BC547 transistor. We have connected transistor base to Arduino pin A0 through a 1k resistor. An AC bulb is used ...

The relay module will need 5V from Arduino to power up and will get input from four different digital pins of the Arduino. Now let’s connect the relay module to your home appliance. Take the positive ...

arduino-relay-control. Control relays using simple serial commands. Supports up to 10 relays. How to use. Connect relays to digital output pins on whatever Arduino via appropriate isolation circuitry, ...

Arduino Relay Driver Shield Circuit Diagram: In this 3-Channel Relay Driver Circuit, we have used an optocoupler to trigger the NPN transistor which further drives the relay. And optocoupler will be ...

In this Lora project, I have shown how to make the LoRa Arduino ESP8266 control relay using the RYLR896 LoRa module with real-time feedback. So after turning on and off the appliances the receiver ...

Arduino Due and the Ethernet shield W5100 have the microcontroller, which has enough GPIO pins for the 16 channel relay , or 2x 8-channel relay. Since Due does not have everyone, the prepared source ...

Here, pin D12 of Arduino is used to drive a standard 5mm LED, and D13 is used to drive an Electro-Magnetic Relay through a transistor-based relay driver. Everytime the tag values match, D13 goes high ...