The RDM6300 125 kHz EM4100 RFID Card ID Reader Module is designed to read and write ... the operating frequency for RC522 is 13.56 kHz. Wire up the Arduino to the RDM6300 RFID Reader Module as shown ...

This project demonstrates how to use an RFID RC522 module with an Arduino to authenticate RFID cards. The system turns on a green LED if an authorized RFID card is scanned and turns on a red LED and ...

As we have learnt in previous tutorials that the XBee module can act as a Coordinator, Router or an End device but it need to be configured to work in desired mode. So before using the XBee modules ...

This module was written using Adobe's Flash Builder 4.6. It depends on the OpenExhibits SDK and the as3glue library. Included in this project is the Firmata_RFID arduino sketch necessary for ...

and only used our voice to customize the module. Each wake word and voice command has its own ID, and that’s what we’d use in an Arduino Sketch as shown below after having installed the DF2301Q ...

Apart from the NFC RFID module, you need only an Arduino board to complement the test setup ... NUID that uniquely identifies the card (it’s possible to have a 7-byte ID as well). Mifare Classic cards ...

At its CES 2020 event, the company introduced its latest creation, the Arduino Portenta H7 module. The device is targeting the IoT industry by providing businesses with an easy and cost-effective way ...