The RDM6300 125 kHz EM4100 RFID Card ID Reader Module is designed to read and write ... the operating frequency for RC522 is 13.56 kHz. Wire up the Arduino to the RDM6300 RFID Reader Module as shown ...

This project demonstrates how to use an RFID RC522 module with an Arduino to authenticate RFID cards. The system turns on a green LED if an authorized RFID card is scanned and turns on a red LED and ...

This module was written using Adobe's Flash Builder 4.6. It depends on the OpenExhibits SDK and the as3glue library. Included in this project is the Firmata_RFID arduino sketch necessary for ...

Apart from the NFC RFID module, you need only an Arduino board to complement the test setup ... NUID that uniquely identifies the card (it’s possible to have a 7-byte ID as well). Mifare Classic cards ...

The hardware is consists of an Arduino microcontroller (here an Arduino Uno R3) and a pre-wired soil moisture sensor module. The soil moisture sensor module , built around the LM393 comparator, gives ...

As we have learnt in previous tutorials that the XBee module can act as a Coordinator, Router or an End device but it need to be configured to work in desired mode. So before using the XBee modules ...

and only used our voice to customize the module. Each wake word and voice command has its own ID, and that’s what we’d use in an Arduino Sketch as shown below after having installed the DF2301Q ...

At its CES 2020 event, the company introduced its latest creation, the Arduino Portenta H7 module. The device is targeting the IoT industry by providing businesses with an easy and cost-effective way ...

Instead, he drew up a simple schematic that used an Arduino Nano, an FM radio module based on the TEA5767, and an audio amplifier based on the LM386. A single button on the Arduino helps cycle ...