I used an old RC car ... code is for steering and is located in the front of the frame and turns to a stop for right or left steering. The "rearMotor" is the motor in the back of the vehicle that ...

This is my first Arduino-based, Bluetooth-controlled RC car ... and use the on-screen controls available on the app to control the car/bot. You could also change the schematic and code, and add some ...

The following sketch will give you a complete understanding on how to control the speed and direction of a DC motor with L293D IC. The code for the Arduino is straight forward ... If you are looking ...

In this project, digital I/O pins 10, 11, 12 and 13 of Arduino are configured as output pins. L293D ... This code will correctly install and save the path of Arduino support package. 6. Open the ...

Then, link each RGB LED's red terminal to an analog ... Important: Always turn off the Arduino power switch and remove external Vin supply when you upload the code. Secure all components to the car ...

Datasheet AMS1117-5V Section 2: Microcontroller( Atmega8/Atmega 328) to control the whole operation of the car. Atmega 328 Datasheet/Atmega 8 Datasheet Section 3: L293D Motor Controller ... App ...

Pins 4 through 7 are connected to H-bridge motor driver L293D IC. Out of these four pins, pins 5 and 6 provide 8-bit PWM output using analogWrite( ) function defined in the asc_car.ino Arduino sketch.