Channel ‘Minority Report’ With Arduino Motion Control Glove for Kinect. By Elizabeth Fish. Jun 6, 2012 2:18 pm PDT. As you all know by now, the Kinect is a pretty epic piece of kit.

The Leap Motion SDK does all the complex stuff, and in the end, just sends a serial command of how many fingers it sees to the Arduino in order to control the hand.

You will need an arduino with serial ports and the arduino IDE. This library might work on other boards that is supported by the IDE but we have not tested them. Contributing ...

[Reza’s] methodical investigation of this remote controlled outlet let him patch in with an Arduino using a 433 MHz transmitter. This is a single-device unit, but the techniques used here sho… ...

Being new to C++ based coding from the Arduino, I think that the code can largely be improved, but ultimately,even with pseudo loops baked into the code, the control unit should be upgraded from ...

It’s a fairly simple project, too: just hook an Arduino Uno up to a motion sensor and an electronic switch called a relay, then plug in your fan, and you’re good to go.

Sometimes, the best Arduino projects are the most ridiculous. Case in point, this motion-detecting squirt gun.The idea is simple: when it detects motion, the spray gun activates.

2. Arduino Uno. 3. L298N motor driver board module. 4. USB cable A to B. 5. Jumper wires pack — M/M. 6. Jumper wires pack — M/F. The schematic diagram shown in Figure 2 illustrates how L298 H-bridge ...