So did [penumbriel], so he built a big red button he could smash instead. This is a very simple hack: an Arduino sits inside a 3D-printed case that holds a big, red button.

[Lars] shows you how to get a perfect score on the first four levels of BIT.TRIP RUNNER by using an Arduino to time and send button presses. This is a pretty simple game that uses a couple of butto… ...

Did you know that you can use Arduino to turn on an LED when you press a button? Well, it is true, you can do this! Leaving the joke aside, let me show how you can achieve this. You will need the ...

My daughter likes buttons. She's learning letters. I was bored over winter break and had these parts laying around... so I built her a "Button Box" based around an Arduino. Open source, hackable ...

Here, a common cathode 7-segment LED display is connected to Arduino for displaying the digits. The code (Arduino sketch) allows push button increment of the counter from 0 to 9. The whole circuit can ...

In this Circuit, we are interfacing Joystick with Arduino simply by controlling four LEDs as per the movement of the Joystick. We have placed 4 LEDs in such a way that they represents the direction of ...

Connection of Potentiometer with Arduino. Next task is to wire the push button to pin Digital Pin 2. The resistor used in this circuit is 1k. The schematic for the same is given below. This will Start ...

The 4×4 keypad connects to the Arduino’s digital pins, with rows attached to pins D9, D8, D7, and D6, and columns to pins D5, D4, D3, and D2. A push button is wired to ground and connected to pin D10 ...

Like xn1ch1’s application, my push-button is connected to the Vcc rail, with a pull-down resistor to 0V. Xn1ch1’s framework stayed the same, with my adaptations limited to altering the states of three ...

Another big issue in this project was button debouncing. The pin on Arduino board, to which the button is connected, is normally pulled down LOW and once we press the button it goes to HIGH. What we ...