For instance, build the receiver for the car and control it with a Wii remote. Or use the controller to play emulator games on an Android phone. Both pieces are Arduino based.

This module is designed to get data from your RC receiver and display each of its channels PWM readings in the terminal monitor. It uses PinChangeInt library to read signals from arduino pins and does ...

Upload the serial_ppm_rx sketch to your Arduino.; Connect your servos to your Arduino per the below pinouts; Run python joystick.py; Use your joystick and watch the servos go! I am using an XBee ...

Over the last few months we’ve seen an influx of homebrew RC controllers come our ... The top 4.3 inch TFT is linked up to a 5.2 GHz video receiver, ... you can always just do it with an Arduino.

The project was designed for Arduino system with the integration of infrared remote control receiver. The use of Arduino system proves to be working fine with any RC5 format remote control. The serial ...

433Mhz Receiver Module. This receiver also very tiny and comes with 4 pins VCC, ground, and the two middle pins are data out. The working voltage of this module is 5v. Like the transmitter module, ...

These days, 433-MHz RF transmitter/receiver modules are very popular with electronics hobbyists and tinkerers. These cheap short-range radio modules can be used with almost all microcontrollers for a ...

24. Receiver Connected to RC System Now, let's test the Arduino-based transmitter and receiver on a brushed hobby-grade RC system. We’ll have the Brushed 2S ESC for driving a car connected to channel ...

Arduino library for Flysky/Turnigy RC iBUS protocol - servo (receive) and sensors/telemetry (send) using hardware UART. The iBUS protocol is a half-duplex protocol developed by Flysky to control ...

Arduino in Control. AR1, an Arduino Nano board (see Figure 4), is used to control this digital FM receiver. It drives a standard 8 x 2 character alphanumeric LCD (LCD1). It reads and reacts to the ...