Here is an artistic Arduino project for the fun-minded. The circuit is an Arduino RGB LED controller running on a sweet ‘n’ simple code,but with a little hardware surprise outside the Arduino board.

What if we can generate different colors using a single RGB led and make our room’s corner more attractive? So, here is a simple Arduino based color mixing lamp which can change color when there is ...

Connect the +ve end of the red led to pin 11 then connect the +ve end of the blue led to pin 10 then connect +ve end of the green led to pin 9. Take all the grounds common and connect to a 1k ohm ...

Tags: Arduino RGB LED library color brightness. This library is created to simplify the steering of a colorful LED. The light emitted from the LED is set through the three color components, i.e. red, ...

Arduino Uno RGB LED Resistor 10K ohm Resistor 221 ohm Jumper wires Pushbutton switch Breadboard Rotary potentiometer. Procedure: You have to wire the schematic as shown in the diagram. Wire the RGB ...

However, you can make any color you could possibly think of by changing which one is turned on and mixing up each one’s brightness. There are two ways to go about lighting an RGB LED module on any ...

WS2811 LED Driver Pinout. GND This pin connects to the ground (GND) or 0V reference of the power supply.. DATA This pin is the data input for the WS2811 driver. It receives the control data from the ...

[Fjord Carver] brings together an RGB LED and CdS Photoresistor to make a color sensor. Those Cadmium Sulfide lights sensors usually have a very wide swing of resistance when exposed to varying lev… ...

When you need to quantify the color of an object, you’ve got quite a few options. You can throw a Raspberry Pi camera and OpenCV at the problem and approach it through software, or you can bu… ...

the RGB LED color mixer is a project that is suitable for the beginner Arduino users who is interested in building an interactive gadget to mix colors. The simple circuit combines three potentiometers ...