CAN protocol communication between 2 Arduino Unos. Contribute to KarthikT23/Arduino-CAN development by creating an account on GitHub.

Choosing a communication protocol ... transfer rate of 2. 5Mbps. 5V MAX485 TTL to RS485 module requires a voltage of 5V and uses 5V logic levels so that it can be interfaced with hardware serial ports ...

Sends and receives data between Arduino boards via I2C. Demonstrates how to configure the Arduino as a master or a slave in an I2C setup.

When [Bill Porter] works on a project, he says that he typically writes his own NMEA standard communications protocols ... packetized serial communications between two Arduino boards.

SPI (Serial Peripheral Interface) is a serial communication protocol ... SPI library used in Arduino IDE. USE: To Initialize the SPI bus by setting SCK, MOSI, and SS to outputs, pulling SCK and MOSI ...

In this tutorial, Myke dives into how to program your Arduino so that you can plan an effective software architecture and monitor your application. Look for new tutorials every 2-3 weeks ... to poll ...

This is a useful addition to my previous article “Arduino EEPROM”. The article is still available. I have provided a link here for convenience https://www.edn.com ...

I2C protocol makes it easier to connect more ICs using only 2 wires SDA and SCL ... in series to pin A4 and A5 on the Arduino board. The two 4.7K pull-up resistors must be used when using I2C ...