Programming Arduino Pro Mini for Rainbow Clock. As I mentioned earlier, the code for this project is not very simple. ... Arduino pin for data input, and push-button pins. #define NUM_LEDS 42 #define ...

Data pins D4 through D7 of LCD1 are directly connected to pins 5, 4, 3 and 2 of Arduino, respectively. Control pins EN and RS of LCD1 are connected to pins 11 and 12 of Arduino, respectively. GPS ...

Unfortunately the i2c pins (A4/SDA and A5/SCL) are not exposed on breadboard friendly pins. I suggest soldering a pair of headers on top of it. Make sure to disconnect the GPS TX/RX when programming, ...

Its pin 19 is for power supply, pins 4 and 9 are for ground, pin 1 for Data In, pin 12 for Load, and pin 13 for Serial Clock. (The pin details are not shown here.) Pin 24 is Data Out pin for ...

This Arduino based Real time clock is a digital clock to display real time using a RTC IC DS1307 which works on I2C protocol. Real time clock means it runs even after power failure. When power is ...

You should connect one of signal lines to some pin of Arduino (A1 is used in project). Note that if you play mono sound then it doesn't matter which signal line to use (Left or Right). When reading ...

The alarm clock is made using a Arduino Mini and a TFT screen. You can turn the alarm on and off by flipping the clock, it’s charged through a micro USB port, and it even senses your presence ...

Maker Michael Klements has built a unique electromechanical clock using a little Arduino hardware, code, and 28 servos, which tilt panels to reveal the Skip to main content Skip to secondary menu ...

Features of the Fibonacci clock include: – The clock is divided into three independents zones: hours, minutes and seconds that use the Fibonacci sequence (1,2,3,5) to simulate counting all the ...