Arduino may be known for revolutionizing open source hardware platforms, but this week it enters the 3D printer market with the small and affordable Materia 101. Produced in partnership with ...

One half of the DVD writer will be used to move the printing bed, and the other will be used to move the 3D printer head. With that in place, add some extra wooden block feet to the base of the ...

2016 is the year of the consumer 3D printer. Yes, the hype over 3D printing has died down since 2012. There were too many 3D printers at Maker Faire three years ago. Nevertheless, sales of 3D print… ...

This Arduino 3D Printer uses five stepper motors in which three of these motors are used for X-axis, Y-axis, and Extruder operation, while the remaining two motors are used for Z-axis operation. These ...

If you are buying a 3D printer with the word "Mini" in the title, you should expect a small bed, but others seem to disagree. The bed on the Mini is 180mm x 180mm, which is not that bad.

My goal with this project was to be able to dynamically know the filament status during the 3D printer operation. I developed this project by mixing design, 3D printing, electronics, software, and of ...

That’s also an interesting project, although it does require a substantial amount of 3D printing and assembly. Back to Lvl2. The best part of the Lvl2 offer is the pricing. For a mere €60 (US$59), ...

Main components: 1 no. Arduino Mega 1 no. Ramps Shield 1.4 4 no. A4988 Motor Driver 1 no. Extruder Module 1 no. hot-end Module 2 no. end-stop Stepper Motor ; 1 no. 12V 5A Power Supply 1 no. Spiral ...