So in this tutorial, we are going to use the TSOP1838 IR receiver to build an IR Remote Decoder using Arduino. The hex code for every button will be logged to Microsoft Excel Sheet. This simple IR ...

to see if the IR receiver pin is high or low with the pulses stored in the ir_pulses array. // With a 16Mhz Arduino clock with the prescaler set to 8 that is 2 clock ticks every microsecond. #define ...

Decodes long IR codes, for example from air conditioner / heat pump devices. Shows the timings, the symbols, and also the decoded signal for certain air conditioners. Connect an IR receiver into the ...

See the block diagram of TSOP1838 below: So far, the setup is already able to sniff IR data packets. But a microcontroller is also required to decode the signals. The additional hardware is just an ...

[Dave Jones] from EEVBlog.com takes “Arduino fan boys” off ... with this excellent tutorial capturing IR codes on his oscilloscope from an IR decoder (yellow trace) as well as using an ...

(This will install all IR libraries in Arduino IDE software.) Every remote has a different code corresponding to each key/button. In order to use your IR remote in this project, you need to decode the ...

The emulation verifies different test cases for the outputs, and the functionality of the IR decoder is confirmed. The final design is also tested with an actual motor for confirmation. 3-speed AC ...

IR_decoder.ino is used for decoding the keys of the remote control. Decoded keys are used in ppt_pointer.ino code in the second part, where each key is assigned to a particular function. It is ...

I made this Arduino project that allows to turn ON and OFF LEDs using a cheap IR remote control as a preparation for the next big step: disassemble my girlfriend’s chinese LED lamp and replace its ...

He put up a great tutorial on using an IR remote to do just about anything with everyone’s favorite microcontroller platform. [firestorm] used the Arduino IRremote library to decode the button ...