News
This is the sketch to display the serial GPS data stream from the Adafruit GPS breakout on a SSD1306 OLED display using the Arduino Nano. Connect the components like this ...
código y diagrama de reloj calendario arruino nano con pantalla oled 7 pines. #include <SPI.h> #include <Wire.h> #include <Adafruit_GFX.h> #include <Adafruit_SSD1306.h> #define SCREEN_WIDTH 128 // ...
This OLED module uses SPI for communication with the microcontroller. SPI is much faster than I2C, and thus we can get a much better frame rate by using the SPI bus. The module we are using has 7 pins ...
The circuit is very simple as we are only connecting the MQ-135 Sensor and OLED Display module with Arduino Nano. MQ-135 Gas Sensor and OLED Display module both are powered with +5V and GND. The ...
The Arduino Nano RP2040 Connect board was announced the day of Raspberry Pi Pico launch as one of the third-party boards featuring Raspberry Pi RP2040 dual-core Cortex-M0+ microcontroller. At the time ...
Figure 4 shows the full pinout of the Arduino Nano RP2040 Connect board, which is also available with header pins pre-installed. Pin layout is well-organized, with all analog and power pins on the ...
This is a driver for SSD1306 and SH1106 128x64, 128x32, 64x48 and 64x32 OLED displays running on the Arduino/ESP8266 & ESP32 and mbed-os platforms. Can be used with either the I2C or SPI version of ...
The screen is, as someone else pointed out, an SSD1306. There are no sprites available. To get a decent update speed, the I²C clock has been pushed up to 800KHz rather than the default 100KHz.
Some results have been hidden because they may be inaccessible to you
Show inaccessible results