Servo motor works on the principal of Pulse Width Modulation (PWM) and its angle of rotation is controlled by the duration of the pulse applied to its control pin. Here in this tutorial we will ...

Using one or two Servo with Arduino is Easy but what if we want to use more than one Servo Motors?. Here, we are going to show you that how to control Multiple Servo Motors with Arduino.Connecting ...

Connect each of the 6 servo motors to the breadboard and ensure each servo's signal wire is connected to the appropriate pin on the Arduino as shown in the image. The power and ground wires of each ...

This project entails designing and programming an electrical circuit for a motor to implementing it for the robot arm. The first task, Bring the breadboard, Arduino, and the five Servos. Then connect ...

The water pump and servo motor are controlled by Arduino connected to digital pins 3 and 9, respectively. That is, the servo motor signal control pin is connected to pin 9 of the Arduino board. Fig. 2 ...

Arduino Uno board (Board1) uses ‘Servo.h’ library to drive these servo motors. The servo motor for the head keeps turning by 180° as already mentioned. The ultrasonic module HC-SR04 is mounted on the ...

In the setup() function we set the pins were the LDR are connected as INPUTs and position the servo motor at 90° then wait for a 2 seconds before the code execution inside the loop(). In the loop() we ...

You'll be working with analog readings from the input (photoresistor) and an Arduino library for the output (servo motor). The entire program is just 33 lines long, and you can opt to modify it to ...