Learn how to integrate a fingerprint sensor and RFID module with Arduino to create a secure ignition system. RFID Based Door Lock System using Raspberry Pi Learn how to build an RFID-Based Door Lock ...

You have seen the RFID Door Lock system ... to digital pin 4 of Arduino, and the GND pin is connected to the ground pin of Arduino. A 10K resistor is used between the VCC and OUT pin of the Hall ...

For my last evaluation assignment I was given the assignment to make an Arduino circuit with 1 controller 1 sensor and 1 output. I wanted to work with the RFID so I thought about ... So I'm going to ...

Using an AVR ATmega168 running the Arduino boot-loader, [pcmofo] has prototyped a two-part design. An RFID reader is mounted outside the door with data wires running to the inside where the ...

Therefore, a home security system prototype that can be accessed by utilizing biometric fingerprint, Radio Frequency Identification (RFID), and keypad sensors was designed and tested. Arduino Uno ...

Electronic and Arduino ... door using a micro servomotor. The DIY biometric lock is also equipped with three push buttons and a 16×2 LCD display. “This is a security door lock with fingerprint ...

This door locking system helps registered users to lock or unlock the door. The door will get unlocked if the card is valid; otherwise, it will be locked. The Arduino board will run with the ...