The Serial Monitor on the computer and the Serial Port on the Arduino must have the same data rate (baud rate). Usually, the baud rate is 9600, so the programming statement is Serial.begin(9600). Set ...

The serial-monitor tool is a command line program that interacts via stdio. It accepts commands as plain ASCII strings terminated with LF \n and sends response as JSON. Install a recent go environment ...

Serial interface for ATTiny that allows you to print different data types to an arduino's serial monitor. Doesn't require any extra serial cables/devices. This uses SoftwareSerial so it's not all too ...

This hack takes advantage of all of these aspects to bring you an Arduino controlled CGA monitor. One problem with experimenting with one of these monitors is that they are not that well documented.

You can read the state of a button using Arduino and a few lines of code. The actual state is shown in the Serial Monitor window as 0 or 1, 0 meaning the button is not pressed and 1 that the button is ...

First we have to program the Arduino to respond to AT commands through Serial monitor. Program is very simple and attached at the end of this tutorial, here we are explaining the program line by line.

Every new generation of computers repeats the techniques used by the earlier generations. [Kim Salmi] created an ASCII-based quadcopter simulation game using an Arduino that displays on the ...

Now wire the hardware as shown here. Open the Serial Monitor in Arduino IDE, hold the RFID Tag very close to the central part of the RFID Reader, and write down the displayed Tag ID. This uniqued ID ...