Step-by-step guide on designing and programming a custom I2C slave sensor device using Arduino. Trump overpowers Musk's attacks on mega tax bill with blizzard of orders Americans are filing for ...

LILYGO T-Embed SI4732 is an ESP32-S3 development board with an AM/FM radio, a TFT display, a rotary encoder, a built-in ...

The ESP32-C61-DevKitC-1 is a development board based on the ESP32-C61 low-cost WiFi 6 and Bluetooth LE 5.0 SoC that was first ...

8-channel piezo-force sensing with high linearity and fast response 16-bit ADC with embedded sensor-fusion MCU for intelligent input processing Multi-protocol support: I2C (Master/Slave), SPI ...

The DB-I2C-S-APB-BRIDGE is an I2C Slave Controller IP Core focused on low VLSI footprint ASIC / ASSP designs not requiring internal configuration & c ...

However you can also output to any other class which inherits from Arduino Print: e.g. the Arduino ESP32 I2SClass or you can use the data callback described below. You can be notified when a packet is ...

Successfully validated on the ESP32 (38 and 30-pin variants) with a 128x64, 0.96" OLED display. Minor adjustments may be needed for other boards or resolutions. i2c_master.h: Provides APIs for I2C ...

The I2C is a two-wire, bi-directional serial bus, that provides a simple and efficient method of short distance data transmission between many devices ...