The code compiles on Arduino IDE 1.8.x or higher with board set to Arduino Uno. The transmitter code is in mtx (master mcu) and stx (slave mcu) folders. The receiver mcu code is in the rx folder. No ...

It is a fully Arduino based RC plane.Flight controller, Transmitter all are made using Arduino.The range is more than 1KM. Transmitter and receiver system are made using arduino and NRF24 ...

It’s winter, and that means terrible weather and very few days where flying RC planes and helicopters ... signals on the receiver to an Arduino, a simple bit of code and the UnoJoy library ...

Presented here is a RF controlled aircraft project based on Arduino ... in the code accordingly. A single-side PCB for the RF controlled aircraft transmitter circuit is shown in Fig. 7 and its ...

Even more recently than that, the idea of an RC transmitter running ... but since the receiver side is no more complicated than another Arduino Nano and NRF24 module, it shouldn’t be hard ...

Showing his journey in building a DSM2 RC transmitter ... Arduino platform and hardware. Check out the video below to learn more about the process and how you can build your very own using the ...

We previously used the same 433 MHz RF modules with Arduino for building projects like Arduino RC Boat, hand gesture controlled robot, etc. The circuit diagram for the transmitter and receiver ...