Next we connected the water flow sensor’s output to the Arduino board (filled with the sketch) and allowed water flow through the water flow sensor at a steady rate of about 1 Litre/minute. Besides ...

We will interface the water flow sensor with Arduino and LCD, and program it to display the volume of water, which has passed through the valve. For this particular project, we are going to use the YF ...

Emergence of Controlled Environment Agriculture (CEA) ranging from computer controlled water irrigation system to lightning and ventilation has changed the conventional scenario of farming. This paper ...

Water Level Sensor Pinout. The working principle of the water level sensor module is very similar to that of a Rain Sensor. The water level sensor has three pins, runs on 5V power, and gives out the ...

Water Level Sensor Pinout The working principle of the water level sensor module is very similar to that of a Rain Sensor. The water level sensor has three pins, runs on 5V power, and gives out the ...

Arduino driver for the Pixart PMW3901 optical flow sensor. The driver is developed to support the Bitcraze Flow Breakout board. It communicates with the sensor using SPI. The library is using the ...

If you're looking for ways to use less water, Instructables user tamberg developed a DIY water faucet sensor that shows you when you've used up a liter. Using an Arduino, flow sensor, and colored ...

In the loop() we check to see if the water level has reached any sensor and if so then turn an the corresponding led. We also use the LCD to display HIGH if the water has reached the highest poing, ...

Circuit diagram of the water flow meter is shown in Fig. 1. The circuit is built around Arduino Uno board (Board1), 16×2 LCD (LCD1), and water flow sensor YF-S201 (SENSOR1). The Arduino is the brain ...

Emergence of Controlled Environment Agriculture (CEA) ranging from computer controlled water irrigation system to lightning and ventilation has changed the conventional scenario of farming. This paper ...