The hardware connection of my Arduino is shown below, to verify the output all we have to do is press the push button and check if the LED is turning on. Then when we release it the LED should turn ...

This project illustrates how to control an LED with a push button connected to an Arduino board. Pressing the button will toggle the LED on and off, making it an excellent introductory project for ...

This project is a simple, yet cool Arduino LED Controller with a button interface. It has been developed by a passionate enthusiast, who is not a professional programmer, but managed to create this ...

Now connect the Arduino with the laptop and choose the board and port correctly and then click the Upload button. After uploading the code, your LEDs should start blinking. So this is how ...

I made this Arduino project that allows to turn ON and OFF LEDs using a cheap IR remote control as a preparation for the next ... You will have to open the serial monitor window and press the remote ...

Looking for a simple circuit to control the light intensity of Light Emitting Diodes (LEDs) or similar lighting sources? Here is an Arduino based circuit with three independent pulse width modulated ...

When the Arduino code sees the button getting pressed, it brings the corresponding LED pin high and starts ... is being done with a stand-alone controller, so the Arduino here is being used ...

Adding a 470-ohm resistor between data pins of Arduino and NeoPixel LEDs can help prevent spikes on the data line, which can damage the first LED. Circuit operation is controlled by the software ...

For information, I found 24V LED garlands at lumitronix web site, with transformer and rectifier. At this stage of the project, I choose to program Arduino to control only one PWM output. Also, I ...