Prior to this code I was unable to find a working code to control a servo motor by incremental control using push buttons instead of utilizing a potentiometer. This code isn't perfect, but it is ...

#Connect 2 push buttons as Yes and No buttons into 1 Analog Input pin. Arduino Single Layer-Single Page Menu With Yes No push buttons This menu containes 4 items. If "No" button pressed change ...

A 16x2 LCD is connected with arduino in 4-bit mode. Control pin RS, RW and En are directly connected to arduino pin 12, GND and 11. And data pin D4-D7 is connected to pins 5, 4, 3 and 2 of arduino.

but for projects like this we cannot use 8 pins of the microcontroller just for push buttons since we might need them for later use. In our case we have the LCD display to be interfaced. So we use the ...

Figure 4 shows the Arduino-Nano board. The board drives an 8*2 LCD (LCD1) and also reads the status of the SW1, SW2, and SW3 push buttons. It also sends/receives the TEA5767 data through the I2C bus.

[Tobie’s] part of the hack is to use an Arduino and a few buttons as the controller. It’s easy to set up and we think the breadboarded controller approximates the size and weight of an LCD ...

An Arduino Nano reads three push buttons for frequency tuning and displays the FM station data on an LCD. FM receivers are among the top popular circuits of any electronic enthusiast. In this article, ...

Platform includes an Arduino form factor ARM mbed shield module and attached sensor endpoint. Shield contains a DS2476 DeepCover ECDSA/SHA-2 coprocessor, LCD, push-button controls, status LEDs and ...