The data pin should be connected to the pin D12 of the Arduino. Here at RF Transmitter side, we have used Arduino Nano. Wiring the receiver module is also very simple, and once again you only need to ...

Configuring XBee Modules using XCTU. As we have learnt in previous tutorials that the XBee module can act as a Coordinator, Router or an End device but it need to be configured to work in desired mode ...

Wireless RF 865MHz module ( WIR-1186, WIR-1386 ) Interfacing with Arduino board he WIR-1186M module is a low-power wireless communication solution that is ideal for Smart Grid, home automation, smart ...

In this project, two Arduino boards will communicate using wireless communication. RF Module: RF Module is a cheap wireless communication module for low cost application. RF Module comprises of a ...

Setting up the Arduino 433-Mz RF Sniffer. ... As you can see, the setup is on the Arduino ground with a 433-MHz receiver module and the USB interface. The code to capture the 433-MHz RF signals is ...

Fig. 2: Circuit diagram for interfacing laser LED module with Arduino. Connect pins 7 and Gnd of Arduino to pins 1 and 3 of KY-008 module, respectively. Run the first sketch (onoff.ino) to turn the ...

RF log detector/controller AD8317 and an Arduino Nano make a compact RF Power Meter possible. The RF front-end is a 4-layer break-out-board ... If all SMDs are mounted on the main PCB solder the two ...

Lantronix is shipping its xPico Arduino Wi-Fi shield which supports a simultaneous wireless LAN interface and access point, and can be used to connect to an Arduino computer using web-based tools and ...