This articles describes how you can use I2C (TWI) communication, Arduino ... TC74 sensor. Wire.available() waits for data to be available on the I2C bus and when the data is received in a 8-bit value ...

Arduino library for interfacing with BME280 temperature and humidity sensor over I2C to Arduino. Simple to use, it enables reading pressure, temperature and humidity from the chip. Additionally, it ...

This is a library for the Arduino IDE that helps interface with ST's VL53L1X time-of-flight distance sensor. The library makes it simple to configure the sensor and read range data from it via I²C.

Bluetooth Low Energy (BLE) is a version of Bluetooth and it is present as a smaller, highly optimized version of the classic Bluetooth. It is also known as Smart Bluetooth. The BLE was designed ...

[Flux Axiom] is using an Arduino Mega in his setup along with a cornucopia of sensors and all their data is being logged onto an SD card. All the code used in his setup is available in his GitHub ...

We have already discussed how to use the NTC thermistor with Arduino. The humidity sensing component ... an event and using this event the temperature and humidity data is read from the DHT11 sensor.

The Arduino ... used to read and write data to and from other devices. The library is essential for DIY projects that involve controlling external components such as sensors, displays, and other ...

This data is used by [934Virginia’s] Arduino library to compare the difference between your target climate and actual sensor readings ... and someone worth reading about. Editor’s Note ...

The LabVIEW 2012 provides a simple interface between temperature sensor and Arduino Uno to read output voltage where LabVIEW further plots the measured temperature data obtained in real time in the ...