News

If your Arduino soil moisture sensor isn't working, check these common issues: verify all wire connections are secure, ensure you're using the correct Arduino pins (A0 for analog, digital pin for ...
Analog Link. It is also possible to read the amount of moisture present in the soil (for judging whether the soil is wet or dry) by linking the analog output (AO) of the module, to one analog input ...
This is a simple arduino project for a soil moisture sensor that will light up a LED at a certain moisture level. It uses Arduino Duemilanove. ... Project source code. const int VAL_PROBE = 0; // ...
This is a Homebridge plugin for an analog soil moisture sensor, working on the Raspberry Pi 3. The actual sensor values are read in by an Arduino, communicated to an Onion Omega2 over UART, and then ...
This project details the construction of a soil moisture sensor using an Arduino Uno microcontroller. The sensor leverages the electrical conductivity of soil to determine its moisture content. Dry ...
In this review of the Maker Uno RP2040 board with the Arduino IDE we could blink LEDs, control RGB LED lights, press the user button to turn on one LED or make the buzzer output some melody, control a ...
You can use any 9v or 12-volt battery. The battery is connected to the Vin and ground pins of Arduino and we can also connect the motor to this battery via a relay. Moisture sensor output is connected ...
The new system uses Arduino-compatible microcontrollers and communication systems to sample and transmit values from four Decagon EC-5 soil moisture sensors. Developing the system required conducting ...
The soil moisture data from the EC-5 sensors installed in the field are wirelessly transmitted from each sensor End Node to the receiver using a long-range package radio (LoRa) transceiver. The ...
After a brief overview of the operating principles of the most common moisture sensors, this article focuses on sensor integration using the Arduino IDE for commonly used boards such as Arduino or ESP ...