Starter code for using an MLX90614 infra-red temperature sensor. The MLX90614 is an infrared thermometer for non-contact temperature measurements made by Melexis. It is available as just the sensor, ...

The current COVID-19 scenario needs no introduction. While everyone is giving their best to move forward, it is important to act responsibly and tackle this problem collectively. Today in many public ...

The Temperature and Humidity Sensor ... pin 2 on the Arduino Mega. +V and GND: Connected to the +5V and GND (ground) of the Arduino Mega, respectively. Open the Arduino IDE and create a new sketch.

we are going to build an RFID based Contactless Temperature Monitoring System using a contactless temperature sensor with Arduino. When employees scan the RFID card, it will measure the body ...

[Flux Axiom] is using an Arduino Mega in his setup along with a cornucopia of sensors and all their data is being logged onto an SD card. All the code used in his setup is available in his GitHub ...

you probably reverse the left and right side of legs of sensor) Now, let’s write some code in Arduino IDE, Now go ahead to upload the code to Arduino and open serial monitor from “Tool” menu of ...