Step 6: Connect your ESP8266 Module and the FTDI board as shown above circuit and make sure your GPIO0 is pulled to ground. To pull down the GPIO0, set the jumper switch as shown in below figure, we ...

Here we are going to program the ESP8266-01 module using the Arduino IDE. For hardware we are using the FTDI board with 3.3V to program ESP8266, since it will make the hardware much simple. The ...

This is the complete wiring diagram using the "wifi/wifi.ino" script. Just follow the simple steps and upload it to your arduino and you are good. The resistor can be any resitor, I use a 1K resistor.

A lot of people have used ESP8266 to add inexpensive WiFi connectivity to their projects, but [Oscar] decided to take it one step further and program an Arduino over WiFi with the ESP8266. [Oscar] … ...

FleaFPA Uno Block Diagram (Click to Enlarge) The Lattice FPGA will come pre-configured with F32c SoC (MIPS-compatible variant) by default, so if you’ll be able to experiment with the board first using ...