Oct 19, 2021 · It described how an Arduino Pro Mini (a low cost Arduino board) could be wired and programmed to respond to function keys on a DCC controller. This opens up a wide world of control options for animations, sound and other options on a DCC equipped model railroad.

It described how an Arduino Pro Mini (a low cost Arduino board) could be wired and programmed to respond to function keys on a DCC controller. This opens up a wide world of control options for animations, sound and other options on a DCC equipped model railroad.

Control your points based on timing? Or even based on track occupancy detection. Computerised turnout control will allow you to automate any movement over your layout. Of course, my current goal is to build a node for the OpenLCB project to control points via servos.

Jan 15, 2015 · Here is the basic circuit for controlling a servo with an Arduino Uno, where the servo draws power from the Arduino. Servos can be independently powered, in which case only the signal wire and ground are connected to the Arduino. Basic Arduino/servo circuit (from www.arduino.cc).

Simple Automated Point to Point Model Railroad : Arduino microcontrollers are great to automate model railroad layouts. Automating layouts is useful for many purposes like putting your layout up at a display where the layout operation can be programmed to run …

Jan 30, 2020 · Each set of points requires 12v DC current, and has three pins : ground, left and right. To switch points requires a momentary pulse (25ms) on the appropriate left or right pin.

In this project we are going to control a number of servos using buttons to select the direction of movement. This project is the second in a series on using an Arduino with servos. This project is aimed at controlling model railway points/turnouts but the code could be used for any project that needs servos controlled with buttons.

EasingFunc<Ease::CubicInOut> easePoint; // Easing function for points bool isSignal; // Whether to animate as a signal or a point // Calculate how much to move the servo

Oct 14, 2023 · I plan to make targets for airsoft practise using buttons and I need to write a program to count and add the points when the bullet hits the button. Also, I would like for the program to send the data via bluetooth and a way to reset the points.

This Arduino recieves i2c commands from the controller, and decodes them to tell a specific servo controlled point to swap to either straight or turnout. A controller can handle up to four nodes, and each node can handle upto 8 points.