Nov 5, 2020 · I am attempting to control a Nema 17 step motor using the Arduino Uno through the stop motion software Dragonframe, and cannot get any motors to move. I have the Arduino …

Nov 6, 2020 · I am trying to control a stepper motor with my Arduino Uno, with a CNC shield and a DRV8825 stepper driver, but I am having troubles for quite some time now. I have been …

Jun 17, 2024 · For this I'm using steppers from old DVD drives, to controll them I use the Arduino CNC shield paired with an Arduino UNO. It already worked connecting them to my PC and …

Nov 7, 2016 · I use GRBL on an Arduino Uno equipped with a CNC Shield V3 because my Mega2560 Marlin board did not work. I finally figured out the end stop pins needed jumpers.

I was using A4988 on a CNC shield which was mounted onto my arduino uno by rexqualis. A couple days ago it was working (inconsistently) to move my NEMA 17 motors.

Jul 14, 2017 · I have an Arduino uno with a CNC Shield, 8825 drivers and a combination of NEMA17 and NEMA23 motors and am using UGS sender. I tested all my drivers individually.

Oct 1, 2022 · Being unable to connect to the UNO probably means you’ve damaged the board. Unless you have experience with electronics, it is easier to just replace the board (s) than try …

Jul 6, 2020 · There is no error occuring and I don't know why, but the stepper motors are just not starting to move. This is the code: #define xlimit_invert 1 //Can be changed to 1 to make the …

Jan 3, 2019 · The heatsync is on one of the 4 stepper drivers plugged into the CNC shield, which is plugged into the arduino. Since then I have replaced the CNC Shield/Stepper Drivers, and …

Nov 16, 2023 · Went to testing the motor and it doesnt work with my arduino uno, cnc shield v3, and stepper drivers. It worked a couple days ago, but just as i need it, it fails. using 12v 2a …