Oct 27, 2019 · We are working on this job that was installed in 1968 with TW solid wire. More than likely the contractor used YELLOW 77 as wire lube. The problem now is that the conduits that go under the basement floor the wire is stuck and will not come out. We have broken several wires trying to pull them out.

Mar 26, 2013 · The most widely accepted method of installation, and the most trouble free, is to wirenut a short length of wire to the two existing wires (do it both to the black and white), and then install the short tail to either a clamp type backwired receptacle or around the screw.

Jul 28, 2011 · One thing to try is to push the wire into the receptacle and then press the lock release and then gently pull the wire out. The complete instructions: With one hand hold the receptacle with the back facing you (difficult to do if you …

Mar 21, 2023 · Here are six very common places that wire connection problems occur. By far the most common problem is when screw terminal connections at wall switches and outlets become loose. Because these fixtures get the most use within an electrical system, these are the places to look first if you suspect wire connection problems.

Jan 20, 2023 · Disconnect the wires from the roof and pull them out from that short elbow. Take the wires in the main panel and wrap them around a 2 foot 2x4 and pull. This should give you the leverage to get around those 4 90 degree bends without damaging the isulation.

Apr 23, 2020 · Run a wire from the other wires so you aren't trying to jam a zillion wires into that box behind the outlet. Get the wires tidy in the outlet before you wire the outlet with the pigtails. You can use stranded to make the final connection and the outlet will slide in easier.

Oct 15, 2024 · In this guide, we’ll give you tips for dealing with the most common problems caused by older, outdated wiring. Some wiring problems are just inconveniences. But others can pose serious fire or electrocution hazards.

Jul 25, 2023 · Poor wire connections are a common cause of electrical faults. They are a human made problem which happens when the wire connection is either over tightened, under tightened or completely missed i.e – screwing into the wire insulation.

The best method to untangle your jammed-up winch cable depends on the jam’s type and severity. Winch cables get stuck for a wide range of reasons. Here are the most common ones, with guidelines on which method to use. Begin with the first recommended method, as it will be the fastest and less likely to cause damage.

Mar 5, 2016 · Used a come-along with strap wrapped around wire. Don't go crazy, put some penetrating fluid in conduit, and then apply tension until wire is taut. Leave it overnight under tension, then try tugging next day.