USBASP is probably the cheapest programmer that can be used to program an Arduino and eliminate the need for a bootloader which occupies 2KB in the on-chip flash. To program an Arduino Uno with a 6-pin ISP connector, the tricky thing is to convert USBASP’s 10-pin connector to 6-pin ISP connector.

Its a run the exe program, no need to install. Plug the USBasp into the PC and it will appear in the Zadig drop down of devices. Select “Install Driver” Connections. To program the AT/ATtiny you have to connect: The 3 SPI port connections: SCK, MISO, MOSI; The reset pin; VCC and GND; Programming Using USBasp & Arduino IDE

In this video I show you how to program your Arduino boards using USBasp programmer. In the video I connect an USBasp programmer to an Arduino board and using Arduino IDE I upload a...

This is another simple project for everyone who always want to program and upload code to their ATmega and Arduino projects. That's why I decided to make my own USBasp. This is a really simple and low-cost project that anyone can make…

Mar 24, 2025 · Among the programmers, the "Arduino as ISP" is the cheapest and most practical solution to burn a bootloader on another Arduino board with ATmega, 32U4 or ATtiny. The programming process uses VCC, GND and four data pins.

Dec 5, 2016 · USBasp and Arduino: The USBasp can be used to load the Arduino boot loader into a microcontroller. To do that, connect the programmer to the MCU as mentioned earlier.

Nov 18, 2018 · To flash Arduino Board or any AVR Boards using the ISP interface, USBasp is the cheap and best option. It supports a wide range of AVR Microcontrollers and easy to use. Using AVR USBasp for programming Arduino Board will give you more Flash memory space than using the Serial USB programming.

Jun 27, 2015 · I was working on a small sketch, and figured, is will use my UsbASP tp program my nano. It's the ebay variant, with outdated firmware. I wasn't using it lately, so never bothered to update the firmware.

Mar 28, 2016 · This tutorial will shows you how to load the program into Arduino using ISP programmer – AVR USBasp, and there are 3 sessions in this tutorial: Load Program into CT-UNO Load Program into BBFuino

This document will explain how to burn Arduino bootloader in a new AVR microcontroller. Introduction : Arduino Bootloader. If you are building your own Arduino, or need to replace the microcontroller of your arduino board you have to burn bootloader before using …